Win3x.Org
http://www.win3x.org/win3board/

Install and run any 16-bit Windows on MS-DOS 6
http://www.win3x.org/win3board/viewtopic.php?f=79&t=5594		 Page 1 sur 1
Auteur :  Matthias [ 11 nov. 2009 20:56 ]
Sujet du message :  Install and run any 16-bit Windows on MS-DOS 6
Yes, you can virtually run any 16-bit Windows on MS-DOS 6.xx!


I. Install DOS

Obviously, don't forget to install DOS prior Windows 1.x, 2.x or even 3.x (except the NT branch).
[en] MS-DOS 6.22 (4.3 Mo) Clics : 4803

II. Install Windows

Download the Windows version you want: viewforum.php?f=34

Extract the archives with 7-Zip, which is probably the best choice (freeware).
Insert the floppy disk n°1 and type on the command prompt:
Code : Tout sélectionner
A:\
Then, type SETUP and follow the instructions on your screen.
To install Windows for Workgroups 3.11 with the Internet support, see another tutorial.


III. Start Windows

When the installation is complete, type:
Code : Tout sélectionner
cd windows 
win
Please note you need to load SETVER before running Windows 1.x or 2.x.
Your config.sys file must contain that line: DEVICE=C:\DOS\SETVER.EXE
To run Windows 1.x on MS-DOS 6.xx, you have to type this on the commands prompt:
Code : Tout sélectionner
SETVER WIN100.BIN 3.30
Reboot the computer so that the modifications take effect.
Auteur :  Big Monstro [ 07 sept. 2015 00:20 ]
Sujet du message :  Re: Install and run any 16-bit Windows on MS-DOS 6
The above text is roughly the English translation of "Comment installer Windows 1.x, 2.x ou 3.x": some parts were edited to emphasize the fact it's possible to run any 16-bit Windows on DOS 6.

Although I translated the tutorial myself, I attributed the previous post to the original author.
Page 1 sur 1 Fuseau horaire sur UTC+02:00
Développé par phpBB® Forum Software © phpBB Limited
Traduction française officielle © Qiaeru