Win3x.Org

device=c:\cardsoft\cs.exe
device=c:\cardsoft\csalloc.exe
device=c:\cardsoft\cardid.exe
install=c:\cardsoft\cs_apm.exe
device=c:\copen\copen.exe

slot 0 :
slot 0 is empty
Slot 1 :
card type unavailable
manufacturer = "unavailable"
Product name = "unavailable"

NDIS 2.0.1 driver for cnf301 pcmcia ethernet controler
1998 ver 2.02
!!no free w89c926 card in socket a-b
press any key to continue...

erreur 7306 : echec d'initialisation du gestionnaire
CNF301.Dos n'a pas été chargé

slot 1 : 
card type unavailable
manufacturer : pcmcia
product name : fastethernet

Memory Window Configuration
CardWorks is currently installed using a 64K memory window in Upper Memory Block (UMB) space in the range D000-DFFF. Many notebooks use a large range of UMB space for other functions and therefore, the only UMB area remaining is the 'D' segment (D000-DFFF) and part of the 'C' segment (CC00-CFFF or C800-CFFF). The current CardWorks installation takes all of the 'D' segment, leaving only a small amount of UMB space free.

On systems with less than 16 MB of memory, PCCARD uses extended memory in the range of 8 Meg to 16 Meg for most of its memory requirements. However, on systems configured with 16 Meg of memory, PCCARD is forced to use UMB memory to locate it's own memory windows. In addition, card drivers which require memory to operate, may also be located in the UMB area on systems which have 16 MB or more of physical memory.

The combined requirements of all drivers for UMB space may exceed the space which remains after the default CardWorks installation. As a result, some cards may not configure properly with CardWorks installed. This is particularly true of LAN cards with memory mapped buffers.

To work-around this problem, you can decrease the amount of UMB space used by CardWorks. Do the following:

1.) Modify CSALLOC.INI
MEMEXCLUDE=C000-CFFF,E000-EFFF
change it to
MEMEXCLUDE=C000-CFFF,D800-EFFF

2.)Modify SYSTEM.INI
EMMEXCLUDE=D000-DFFF
if it is there, change it to
EMMEXCLUDE=D000-D7FF

3.) If EMM386.EXE is loaded, modify CONFIG.SYS
device=emm386.exe noems x=d000-dfff
to
device=emm386.exe noems x=d000-d7FF

device=c:\dos\emm386.exe noems

device=c:\dos\emm386.exe noems x=d000-dfff

DEVICEHIGH=C:\CARDSOFT\SSVADEM.EXE (socket service driver, testé le ss365sl.exe marche aussi

DEVICEHIGH=C:\CARDSOFT\CS.EXE
DEVICEHIGH=C:\CARDSOFT\CSALLOC.EXE
DEVICEHIGH=C:\CARDSOFT\CARDID.EXE